Warmup is switched off on a mailbox when warmup emails sent to it are rejected. Other mailboxes in the warmup network can't reach it, so Smartlead blocks its warmup until you fix it.
Not every bounce blocks warmup. Only a hard failure, such as "mailbox does not exist", blocks it. A softer bounce only puts warmup into a cool-down.
Common causes and fixes
The mailbox can't receive email
When a warmup email bounces, Smartlead checks the mailbox that caused it. This is usually the receiving mailbox. If an email checker confirms the address is fine, nothing is blocked. If the address fails, warmup on that mailbox is blocked.
Send a test email to the mailbox from an address outside your company.
Check it arrives. If it doesn't, fix the mailbox with your email provider first. For example, make sure the mailbox exists and is active.
Check your domain's MX, SPF, DKIM and DMARC records are set up and resolving.
Unblock one mailbox
Open the mailbox and go to its Warm Up tab.
Read the error shown in the banner. It is the bounce message Smartlead received.
Under Generate Intell-Unblock Code, click Unblock Mailbox.
Smartlead emails an unblock code to the mailbox itself. Copy the code from that email.
Paste the code into the field that appears and click Verify Mailbox.
The code proves the mailbox can receive email again, and warmup restarts.
If the banner says your MX records were not resolving, fix the records first. Then click Unblock Warmup Mailbox. This unblocks every mailbox on that domain with the same MX issue.
Unblock many mailboxes
To unblock several blocked mailboxes in one go, use bulk unblock from Sender Accounts. See How to Bulk Unblock Warmup Mailboxes in Smartlead.
Warmup gets blocked again
If the mailbox receives outside mail but warmup is blocked again with "mailbox does not exist", contact support. Include the mailbox address and the error from the Warm Up tab.
Good to know
Your mailboxes only exchange warmup emails with mailboxes in your plan's warmup pool. Base plans use the Foundation pool, Pro uses Growth, and Unlimited or Prime use Premium.
You can see your current pool in the banner at the top of Sender Accounts.
Still stuck? Contact support from the chat in your Smartlead dashboard.
